Location: Welcome to the WOOD Wiki

Discussion: Making an Octagon from plywoodReported This is a featured thread

Category: Discussion Forum / General Discussion
Showing 3 posts

Posted Anonymously
Making an Octagon from plywood
Mar 9 2009, 11:56 AM EDT | Post edited: Mar 9 2009, 11:56 AM EDT
Any thoughts on how to make a octagon on a table saw.It is for a poker table pedistal. 1  out of 1 found this valuable. Do you?    
Keyword tags: None (edit keyword tags)

Posted Anonymously
1. RE: Making an Octagon from plywood
Apr 8 2009, 8:52 AM EDT | Post edited: Apr 8 2009, 8:52 AM EDT
If you are making an octogon the angles would be 22 1/2 degrees. Do you find this valuable?    

Posted Anonymously
2. RE: Making an Octagon from plywood
Apr 8 2009, 8:55 AM EDT | Post edited: Apr 8 2009, 8:55 AM EDT
To make an octogon the angles would be cut at 22 1/2 degrees. Do you find this valuable?